In some cases, the buttons may get stuck.
#URC REMOTE INPUT BUTTON PRESSES THREE TIMES CODE#
If the TV button flashes when the volume button is pressed but there is still no volume control, this indicates that the TV code needs to be programmed into the remote control.The TV button on top should light up and a volume bar should appear on the television screen. To verify if it is programmed, press the Volume button.In order to control the volume using the Shaw Direct remote, make sure you programmed it first. If no button flashes, try changing the batteries of the remote.If you are trying to change channels and other buttons (TV, AUX) flash red, press the SAT button.Press and hold the ENTER/OK button on your Shaw Direct remote.Press and release each device key (SAT, TV, or AUX) that you wish to have programmed in the order you want them toggled when POWER is pressed.Press and hold SAT until the other buttons (TV and AUX) flash at least three times.If held for less than three seconds, POWER button will only turn your receiver on or off. Note: POWER button must be held down for roughly three seconds in order to toggle all devices. To have POWER button toggle your satellite receiver and other devices (such as your TV) on and off at the same time, follow the instructions below. Press the POWER button to turn back on the receiver.īy default, pressing POWER button on your Shaw Direct remote will only toggle your satellite receiver on and off.Make sure to not press the button again once the receiver is off. Press CH+button once per second until the receiver turns off.Press and hold SAT button until the others (TV, AUX) flash at least 3 to 4 times.If not, repeat steps 1-3 using different codes.Press the POWER button to turn the receiver back on. If receiver turns off, your remote has been successfully programmed.After punching in the code, press the POWER button and see if the receiver turns off.
See My receiver changes channels itself for more information.īoth your satellite receiver and Shaw Direct remote need to be changed to a new address in order to keep them tied together.įollow the steps below to program your remote. If two UHF-enabled receivers are in close distance to each other, the remotes may control the incorrect receiver however, you can set a custom remote address to prevent this. Some satellite receivers are ultra high frequency (UHF)-capable, which allows them to receive remote commands when the remote does not have a direct line of sight to the receiver.
Press CH+ button once per second until the TV turns off.Press and hold the TV button until the others (AUX, SAT) flash at least 3 to 4 times.If not, repeat steps 2-3 using different codes given for your brand of the TV.Press the POWER button to turn it back on. If the TV turns off, you have successfully programmed your remote with the TV.Press in the 5-digit code that you noted down.On the top of your remote, press and hold the TV button until the others (AUX, SAT) flash at least 3 to 4 times.You can have your Shaw Direct remote control other devices, such as your TV, with the following methods:ĭownload this file and search for your TV brand.
0 kommentar(er)
